ZyXEL Communications NBG420N - Manual (Page 212)

Chapter 18 Remote Management
NBG420N User’s Guide
212
18.5 FTP Screen
You can use FTP (File Transfer Protocol) to upload and download the NBG420N’s firmware
and configuration files. To use this feature, your computer must have an FTP client.
To change your NBG420N’s FTP settings, click Management > Remote MGMT > FTP. The
screen appears as shown. Use this screen to specify which interfaces allow FTP access and
from which IP address the access can come.
Figure 128 Management > Remote MGMT > FTP
The following table describes the labels in this screen.
18.6 DNS Screen
Use DNS (Domain Name System) to map a domain name to its corresponding IP address and
vice versa. Refer to the chapter on Wizard Setup for background information.
To change your NBG420N’s DNS settings, click Management > Remote MGMT > DNS.
The screen appears as shown.
Table 81 Management > Remote MGMT > FTP
LABEL DESCRIPTION
Server Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Server Access Select the interface(s) through which a computer may access the NBG420N using
this service.
Secured Client IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the
NBG420N using this service.
Select All to allow any computer to access the NBG420N using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the NBG420N using this service.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.