ZyXEL Communications ZyXEL Dimension ES-2024 - Manual (Page 157)

Dimension ES-2024 Ethernet Switch
Introduction to CLI 25-7
Table 25-2 Command Summary: sys sw
COMMAND DESCRIPTION
delentry Deletes the specified (VID) static
VLAN.
active Turns on the specified static
VLAN.
inactive Turns off the specified static
VLAN.
list Displays a table of static VLANs.
vlan list Shows the specified IEEE
802.1Q Tagged VLAN table.
status Shows the IEEE 802.1Q tagged
status.
driver config Shows the switch’s settings.
count disp Shows the switch Network Driver
Interface Specifications (NDIS)
level counters (CPU interface).
clear Clears the switch NDIS level
counters (CPU interface).
rstp
All “sys sw rstp” commands relate
to rapid STP configuration. Refer
to IEEE Std 802.1w. Use “config
save” to save your configuration
changes.
bridge
enable Enables RSTP.
disable Disables RSTP.
priority Sets the system priority.
maxage Sets the max age timer
hellotime Sets the hello timer.
forwardDelay Sets the forward delay time
version Displays/enables the STP mode;
STP or RSTP. RSTP is the
default used when configuring
STP via web configurator.
port
enable Enables RSTP on this port.
disable Disables RSTP on this port.
pathCost Sets the specified port’s path
cost.
priority Sets the specified port’s priority.
edgeport Displays if this port is an edge
port.