ZyXEL Communications ZyXEL Dimension ES-2024 - Manual (Page 156)

Dimension ES-2024 Ethernet Switch
25-6 Introduction to CLI
The following commands are system switch commands; all are preceded with sys sw
Table 25-2 Command Summary: sys sw
COMMAND DESCRIPTION
garp status Shows the GARP timer status.
timer timer(ms)>
timer(ms)>
Sets the GARP timer’s Join
Timer, Leave Timer and Leave
All Timer.
gvrp trace Sets GVRP trace level.
status Shows the GVRP status.
enable Enables GVRP.
disable Disables GVRP.
pktcnt 1-26> Display port statistic counter.
pktcntclear Reset port statistic counter.
port Port setup.
portstatus Displays current port status and
settings.
phyread [] Reads PHY register.
phywrite Writes PHY register.
qos defpri [<0:none | 1:low | 2:high>] Sets the default ingress User
Priority for a port.
map <0..7> [<0:low | 1:high>] Maps a User Priority to a Traffic
Class.
method <0:FCFS | 1:Strict | 2:WRR [high
weight] [low weight]>
Sets the QoS method.
showmethod Displays the QoS method.
vlan1q All “sys sw vlan1q” commands
relate to IEEE 802.1Q Tagged
VLAN configuration. Use “config
save” to save your configuration
changes.
port status Shows a port’s VLAN information.
defaultVID Sets the default VLAN ID of a
port.
accept Sets the type of frames that a
port accepts.
gvrp Enables/disables GVRP on the
specified port.
svlan cpu Sets the VLAN ID of the
management VLAN (CPU).
setentry Applies a static VLAN (name,
admin control tag, tag control) to
a port.