Texas Instruments TSB12LV26 - Manual (Page 65)

4–27
4.31 Isochronous Cycle Timer Register
The isochronous cycle timer register indicates the current cycle number and offset. When the TSB12LV26 is cycle
master, this register is transmitted with the cycle start message. When the TSB12LV26 is not cycle master, this
register is loaded with the data field in an incoming cycle start. In the event that the cycle start message is not received,
the fields can continue incrementing on their own (if programmed) to maintain a local time reference. See Table 4–22
for a complete description of the register contents.
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
Name Isochronous cycle timer
Type RWU RWU RWU RWU RWU RWU RWU RWU RWU RWU RWU RWU RWU RWU RWU RWU
Default X X X X X X X X X X X X X X X X
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Name Isochronous cycle timer
Type RWU RWU RWU RWU RWU RWU RWU RWU RWU RWU RWU RWU RWU RWU RWU RWU
Default X X X X X X X X X X X X X X X X
Register: Isochronous cycle timer
Type: Read/Write/Update
Offset: F0h
Default: XXXX XXXXh
Table 4–22. Isochronous Cycle Timer Register Description
BIT FIELD NAME TYPE DESCRIPTION
31–25 cycleSeconds RWU This field counts seconds [rollovers from bits 24–12 (cycleCount field)] modulo 128.
24–12 cycleCount RWU This field counts cycles [rollovers from bits 11–0 (cycleOffset field)] modulo 8000.
11–0 cycleOffset RWU
This field counts 24.576-MHz clocks modulo 3072, i.e., 125
µ
s. If an external 8-kHz clock configuration
is being used, then this bit must be cleared to 0 at each tick of the external clock.