Texas Instruments TSB12LV26 - Manual (Page 48)

4–10
4.10 GUID High Register
The GUID high register represents the upper quadlet in a 64-bit global unique ID (GUID) which maps to the third
quadlet in the Bus_Info_Block. This register contains node_vendor_ID and chip_ID_hi fields. This register initializes
to 0s on a hardware reset, which is an illegal GUID value. If a serial ROM is detected, then the contents of this register
are loaded through the serial ROM interface after a PCI reset. At that point, the contents of this register cannot be
changed. If no serial ROM is detected, then the contents of this register are loaded by the BIOS after a PCI reset.
At that point, the contents of this register cannot be changed.
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
Name GUID high
Type R R R R R R R R R R R R R R R R
Default 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Name GUID high
Type R R R R R R R R R R R R R R R R
Default 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Register: GUID high
Type: Read-only
Offset: 24h
Default: 0000 0000h
4.11 GUID Low Register
The GUID low register represents the lower quadlet in a 64-bit global unique ID (GUID) which maps to chip_ID_lo
in the Bus_Info_Block. This register initializes to 0s on a hardware reset and behaves identically to the GUID high
register (OHCI offset 24h, see Section 4.10).
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
Name GUID low
Type R R R R R R R R R R R R R R R R
Default 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Name GUID low
Type R R R R R R R R R R R R R R R R
Default 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Register: GUID low
Type: Read-only
Offset: 28h
Default: 0000 0000h