4 hardware installation – Texas Instruments MSP50C614 User Manual
Page 305
Hardware Installation
5-5
Code Development Tools
5.4
Hardware Installation
The following steps are used to set up the hardware (see Figure 5–2):
1) Connect the 18 V power supply to the MSPSI and connect the mains pins
to a 120 V, 60 Hz ac source.
2) Connect one end of the IEEE1284 parallel cable to the MSPSI board and
the other end to the PC parallel port.
The red (power) LED should be ON. The yellow (Emul/Prog) LED comes ON
when entering into emulation mode or during programming. The green (target)
LED is ON if the MSPSI is connected to a target board that has power applied.
Figure 5–2. Hardware Installation
MSP Scanport
Interface (MSPSI)
RED
LED
GREEN
LED
YELLOW
LED
MSP50P614
Target development
board
IEEE1284
Parallel
Port Cable
PC Parallel port
18 V DC
Target board power
Target
board
connector
LED DESCRIPTION
Red
MSPI power
Yellow
Emulation mode/programming (Emul/Prog)
Green
Target board power