Tektronix PHASER 380 - Manual (Page 36)

2 Getting Set Up
2-18 Phaser 380 Color Printer
Loading transparencies in the media tray
1. Prior to loading transparencies in the upper media tray, fan the
transparencies to release sheets that are stuck together. Always
handle transparencies by the edges and with both hands to avoid
Þngerprints and creases, which can result in poor print quality.
2. Load up to 100 transparency sheets in the upper media tray. A
label on the inside of the paper tray provides a Þll line to indicate
the trayÕs maximum capacity.
Note If you are using Tektronix transparency media, you must position
the transparency notch in the back, right corner of the tray. Jams
will occur if transparencies are incorrectly loaded.
3. Pressing both blue tabs at the same time, adjust the side and end
stops to Þt snugly against the loaded transparencies.
4. Set the media selector switch on the side of the tray in the lower
position for Transparency.
1
2
9662-56
3
4