Tektronix PHASER 380 - Manual (Page 19)

User Manual 2-1
Chapter
2
Getting Set Up
At a glance
Installation of your printer involves these tasks:
1. Setting up the printer (page 2-2).
Putting all the pieces together: unpacking the printer and accessories,
installing the optional equipment such as the Lower Paper Tray
Assembly, Printer Station and Phaser Copystation, loading the media
tray(s), loading ink sticks, and installing the maintenance tray.
Note For instructions on installing a SCSI hard disk for font storage and/or
print collation, refer to the CD-ROM that came with your printer.
2. Connecting the power and interface cables (page 2-20).
3. Selecting a language for the front panel (page 2-29).
4. Installing printer driver software on your computer (page 2-31).
Using the Printer Software diskettes or the printerÕs CD-ROM
to install software Ð for example, drivers, PostScript Printer
Description (PPD) Þles and utility Þles Ð on a Macintosh, or a PC
running Windows 95, Windows 3.1, or Windows NT.
Caution To ensure proper printer operation, install the printer on a ßat
surface having no more than 2 degrees of tilt. This is
approximately equivalent to lifting one side of the printer
16 mm (0.625 in.) off a level surface.