Tektronix PHASER 380 - Manual (Page 258)

9 Regulatory Information and Specifications
9-6 Phaser 380 Color Printer
MSDS for silicone oil
Section I – Product identification
Trade name and Tektronix part number:
Silicone fluid (found in maintenance tray) 006-7912-00
Product use: Used in Tektronix Phaser 380 color printers.
Section II – Information on ingredients
Ingredients
Polydimethylsiloxane
CAS Number: 63148-62-9
Hazardous Ingredients: None. This is not a hazardous material as defined by the OSHA Hazard
Communication Standard.
Section III – Hazards identification
Potential Health Effects:
Eyes: Direct contact may cause temporary discomfort with mild redness and dryness similar to windburn.
Skin: A single prolonged exposure (24 to 48 hours) causes no known adverse effect.
Inhalation: Not an irritant to respiratory passages.
Ingestion: Swallowing large amounts could cause discomfort
.
Section IV – First aid measures
Eyes: Flush immediately with water.
Skin: Wipe off and wash with soap and water.
Inhalation: Not a likely route of exposure.
Oral: No first aid should be needed.
Section V – Fire fighting measures
Flammable Properties: Flammable limits not determined.
Flash point: 284.9
°
C ( 545
°
F), minimum open cup.
Fire & explosion hazards: No unusual hazards known.
Section VI – Accidental release measures
Spill Or Leak: Wipe with absorbent material and dispose in accordance with Federal, State, and Local regulations.
Section VII – Handling and storage
Handling: No special requirements.
Storage: No special requirements.
Section VIII – Exposure control – personal protection
Exposure Guidelines: None established.
Engineering Controls: None needed when used as intended in Tektronix printers.
Eye Protection: None needed.
Skin Protection: None should be needed.
Respiratory Protection: None needed.