T-Mobile MDA III - Manual (Page 91)

T-Mobile III User Manual
90 T-Mobile MDA III User Manual 91
Setting up an ActiveSync via Bluetooth on your T-Mobile MDA III
You can set up an ActiveSync partnership with a Bluetooth - enabled computer. First, you need
to set up the Bluetooth Configuration of your computer (follow the instruction in the user manual
of your Bluetooth device or PC), then setting up your T-Mobile MDA III.
To establish an ActiveSync connection on your T-Mobile MDA III:
1. From the Today screen > tap Bluetooth icon > Bluetooth Manager.
2. Tap New > ActiveSync via Bluetooth > Next .
3. Follow the connection wizard instructions.
Be sure the ActiveSync COM port setting on your PC is the same as the COM port setting used for
Bluetooth on your PC.
4. Follow the Bluetooth Browser screen, select the PC you want to synchronize with > tap Next .
5. Under Serial Port Selection > select the name of the serial port for the PC selected above > then
tap Next > Finish.
Connect to a remote PC
Dial-up Networking (DUN) allows you to connect to a remote computer via a phone line. Once
connected, you can browse the Internet, check your E-mail, etc.
The remote
Bluetooth device that will provide the Dial-up Networking service must have ac-
cess to a telephone system (either a hard-wired or cellular connection).
Devices that might provide the
Dial-up Networking service include:
n Bluetooth-enabled cellular telephones.
n Bluetooth-enabled desktop computers that are attached to a telephone system.
n Bluetooth modems.
The remote computer to which you are connecting must also be attached to the phone system
and capable of answering a call.
To use
Dial-up Networking :
1. From the Today screen > tap Bluetooth icon > Bluetooth Manager.
2. Tap New > Connect to a network > Next .
3. Follow the connection wizard instructions.
After you create the Dial-up Networking shortcut with a device, tap and hold the shortcut icon in
the My Shortcuts tab of the Bluetooth Manager , and tap Connect .
4. Tap New Connection > Tap OK .
5. Enter a name for the connection in the Connection Name field.