T-Mobile MDA III - Manual (Page 165)

T-Mobile MDA III User Manual 164 T-Mobile MDA III User Manual 165
FCC Compliance
Statement
n FCC part 15, 22 and part 24
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions : (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
n FCC ID : NM8 BLUEANGEL
n Statement according to FCC part 15.105
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures .
n Reorient or relocate the receiving
antenna.
n Increase the separation between the
equipment and receiver.
n Consult the dealer or an experienced radio/
TV technician for help.
n Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
n RF EXPOSURES
Tests for SAR are conducted using standard
operating positions specified by the FCC with
the phone transmitting at its highest certified
power level in all tested frequency bands.
Although the SAR is determined at the highest
certified power level, the actual SAR level of
the phone during operation can be well below
the maximum value. This is because the phone
is designed to operate at multiple power levels
so as to use only the power required to reach
the network. In general, the closer you are to
a wireless base station antenna, the lower the
power output.
Before a phone model is available for sale to the
public, it must be tested and certified to the FCC
that it does not exceed the limit established by
the government-adopted requirement for safe
exposure. The tests are performed in positions and
locations (e.g., at the ear and worn on the body) as
required by the FCC for each model. (Body-worn
measurements may differ among phone models,
depending upon available accessories and FCC
requirements). While there may be differences
between the SAR levels of various phones and at
various positions, they all meet the government
requirement for safe exposure.
For body worn operation, to maintain compliance
with FCC RF exposure guidelines, use only High
Tech computer, Corp. approved accessories.
When carrying the phone while it is on, use the
specific High Tech Computer Corp. supplied or
approved carrying case, holster, or other body-
worn accessory.
Use of non High Tech Computer Corp. approved
accessories may violate FCC RF exposure
guidelines and should be avoided.