Tunturi R60 User Manual
Page 3
G B
3
O W N E R ' S M A N U A L
•
R 6 0
maintenance instructions described in
this manual.
•
The equipment must not be used by
persons weighing over 135 kg.
•
Do not attempt any servicing or
adjustments other than those described
in this guide. Everything else must
be left to someone familiar with the
maintenance of electromechanical
equipments and authorised under the
laws of the country in question to carry
out maintenance and repair work.
SAVE THIS INSTRUCTION MANUAL
WELCOME TO THE WORLD OF TUNTURI
EXERCISING!
Your choice shows that you really want to
invest in your well being and condition; it
also shows you really value high quality
and style. With Tunturi Fitness Equipment,
you’ve chosen a high quality, safe and
motivating product as your training partner.
Whatever your goal in training, we are
certain this is the training equipment to get
you there. You’ll find information about using
your exercise equipment and what makes
for efficient training at Tunturi’s website at
WWW.TUNTURI.COM
.
ASSEMBLY
The rowing machine is shipped in the
locked storage position. Unlock the front
tube’s latch under the seat and push the
seat back. Push the front tube folded on
the frame up and forward. Pull the locking
pin up and press the front frame downward
simultaneously by the pulley wheel cover.
Release the locking pin and ensure that the
front frame is in locked forward position.
Always tighten the locking pin before you
begin to exercise.
CONSOLE
Turn the console carefully away from the
front frame so that you can remove the
battery compartment cover in the back of
the console. Open the battery compartment
cover carefully from its lower edge. Press in
the tab at the bottom of the cover to unlock
it, then lift the cover up. Be careful not to
damage the wires. Set the batteries (4 x
C) in their place according to the markings
in the battery compartment. Reattach the
cover and adjust the angle of the console
appropriately for exercise. The clock in the
console uses always batteries, even when
the device is not connected to any power
source. Otherwise the clock would reset to
zero.
Adjust the console so that it is in an
appropriate angle for excercise.
TRANSFORMER
Connect the transformer power cord to
a receptacle. Connect the transformer
connector to the plug in the front frame.
Always disconnect the power cord from the
device and the receptacle after you finish.
NOTE!
Always remove the mains cable from
the fitness equipment first, and only then
remove it from the power source. Always
connect the mains cable to the power source
first, and only then connect it to the fitness
equipment. Inverted order resets the meter
clock display.