Raritan Computer Home Security System - Manual (Page 309)

Chapter 16: Diagnostic Console
291
Password setting Description
every password must have at least one digit in it.
Diagnostic Console Account Configuration
By default, the status account does not require a password, but you can
configure it to require one. Other aspects of the admin password can be
configured and the Field Support accounts can be enabled or disabled.
To configure accounts:
1. Choose Operation > Admin > DiagCon Passwords > Account
Configuration.
2. In the screen that appears, you can view the settings for each
account: Status, Admin, FS1, and FS2.
This screen is split into three main areas:
ƒ The top displays read-only information about the accounts on the
system.
ƒ The middle section displays the various parameters related and
pertinent to each ID, along with a set of buttons to allow the
parameters to be updated or new passwords provided for the
accounts.
ƒ The lower area restores the password configuration to Factory
Defaults (or to how the system was initially shipped).
3. If you want to require a password for the Status account, select
Enabled underneath it.
4. For the Admin and Status accounts, you can configure: