Ricoh 220-240 V - Manual (Page 281)

Message List
271
6
Name registration success. WINS Serv-
er= NetBIOS
Name= Name registration of to
was successful.
Name registration success in Broadcast
name= Name registration by Broadcast name of BIOS Name> was successful.
Name registration failed. name=name> Name registration of failed.
Change to different NetBIOS name.
nbtd start. The nbtd service has started.
nprinter start (Netware) (In the remote printer mode) The NetWare ser-
vice has started.
nwstart start. (NetWare) The service for NetWare protocol stack setting
has started.
Open log file (In the print server mode)The specified log file
has been opened.
phy release file open failed. Replacing the network interface board is required.
Contact your sales or service representative.
Print queue cannot be
serviced by printer 0, (In the print server mode) The print queue
cannot be established. Make sure that print
queue exists on the specified file server.
Print server has no print-
er. (In the print server mode) The printer is not as-
signed to the print server. Using NWadmin,
assign the printer, and then restart it.
print session full No more print jobs can be accepted.
Printer has no queue (In the print server mode)The print queue is not
assigned to the printer. Using NWadmin, assign
the print queue to the printer, and then restart it.
pserver start. (NetWare) (In the print server mode)The NetWare service
has started.
Required file server () not found The required file server is not found.
received EAP Failure EAP reception failed.
restarted. The lpd service has started.
sap enable, saptype=, sap-
name= The SAP function has started.The SAP packet
is issued to advertise the service on the SAP ta-
ble on the NetWare server.
server identity invalid The server ID is disabled. Check the server au-
thentication.
session IPv4 not defined. The requested community name is not defined.
session IPv6 not defined. The requested community name is not defined.
session already defined. The requested community name is not defined.
session_ipx not defined. The requested community name is not defined.
Set context to An NDS context name has been set.
smbd start. (NETBIOS) The smbd service has started.
Message Problem and solutions