Ricoh 220-240 V - Manual (Page 246)

Monitoring and Configuring the Printer
236
6
❖ Adding a specified IPv6 destination to Routing Table
msh> route add6 {destination} prefixlen gateway
• Specify the IPv6 address to destination and gateway.
❖ Deleting a specified IPv6 destination from Routing Table
msh> route delete6 {destination} prefixlen
• Specify the IPv6 address to destination and gateway.
❖ Display information about a specified IPv6 route information
msh> route get6 {destination}
• Specify the IPv6 address to destination and gateway.
❖ Enabling/disabling a specified IPv6 destination
msh> route active6 {destination} prefixlen {on | off}
❖ Route initialization
msh> route flush
Note
❒ The maximum number of IPv4 routing tables is 16.
❒ The maximum number of IPv6 routing tables is 2.
❒ Set a gateway address when communicating with devices on an external network.
❒ The same gateway address is shared by all interfaces.
❒ “Prefixlen” is a number between 1 and 128.
set
Use the "set" command to set the protocol information display "active" or "inac-
tive".
❖ View settings
The following command displays protocol information (active/inactive).
msh> set ipv4
msh> set ipv6
msh> set appletalk
msh> set netware
msh> set smb
msh> set protocol
• When protocol is specified, information about TCP/IP, AppleTalk, Net-
ware, SCSI print, PictBridge and SMB appears.
msh> set parallel
msh> set usb
msh> set lpr