Ricoh 220-240 V User Manual
Page 279
Message List
269
6
Attach to print queue
(In the print server mode) Attached to the
print queue.
Authentication mode mismatch< SSID >
Authentication mode is different to the AP.
The required SSID is the SSID of the access
point connected to when in infrastructure
mode.
centrod is disabled.
Communication via parallel connectionis un-
available because centrod is disabled in the se-
curity mode.
Enable centrod in the security mode.
Cannot create service connection
(In the remote printer mode) Connection to the
file server has not been established. The num-
ber of file server users may have exceeded the
maximum capacity of the file server.
Cannot find rprinter (
The printer with the number displayed on the
print server does not exist. Make sure that the
printer number is registered on the print serv-
er.
Change IP address from DHCP Server.
The IP address changes when DHCP lease is
renewed. To always assign the same IP ad-
dress, set a static IP address to the DHCP serv-
er.
child process exec error! (process name)
The network service failed to start. Turn the
printer off and then on. If this does not work,
contact your service or sales representative.
Client password rejected
The client's password was rejected. Check the
client password.
Client tls certificate rejected
The client's TLS certificate was rejected. Check
the certificate.
Connected DHCP Server(
The IP address was successfully received from
the DHCP server.
Could not attach to FileServer
file server has not been established. The file
server has refused the connection. Check the
file server configuration.
Could not attach to PServer
(In the remote printermode) Connection to the
print server has not been established. The
print server has refused the connection. Check
the print server configuration.
Current Interface Speed: xxxMbps
Speed of the network (10Mbps, 100 Mbps, or
1Gbps).
Current IP address
Current IPv4 address.
Current IPX address
Current IPX address
DHCP lease time expired.
DHCP lease time has expired.The printer tries
to discover the DHCP server again. The IP ad-
dress until now becomes invalid.
Message
Problem and solutions