Ricoh 220-240 V - Manual (Page 234)

Monitoring and Configuring the Printer
224
6
autonet
Use the “autonet” command to view and configure AutoNet parameters.
❖ View settings
The following command displays the current AutoNet settings:
msh> autonet
❖ Configuration
You can configure AutoNet settings.
msh> autonet {on|off}
• {on} means “active” and {off} means “inactive”.
❖ Current interface priority configuration display
msh> autonet priority
❖ Interface priority configuration
msh> autonet priority “interface_name”
• You can give interface's AutoNet parameter priority.
• Priority settings are available when multiple interfaces are installed.
• wlan can be specified only when the IEEE 802.11b interface is installed.
Note
❒ If an interface is not selected, the current interface connection settings remain
in effect.
Reference
For details about AutoNet, refer to autonet parameters.
Interface name Interface configured
ether Ethernet interface
wlan IEEE 802.11b interface