Nortel Networks M3110 User Manual
Page 53
Attendant consoles
Page 53 of 504
Telephones and Consoles
Description, Installation, and Operation
Switches
A slider control, located below the dial pad, between columns DI/EI and FI,
controls the handset and headset receive volume level. See Figure 10 on
.
A Power Fail Transfer (PFT) switch is located in the baseplate. See Figure 11
on
. Both the line connector and the RS-232 connector for the PC port
are located at the back of the console.
Shift key
The Shift key is positioned in column FK, row 1, just above the Hold key. See
Figure 10 on
. It is used to access Level 1 mode functions.
Handset and headset jacks
Two pairs of jacks are provided for plugging in handsets or headsets. The
jacks are located on both sides of the console beneath the faceplate in the
recessed area shown by the arrows. See Figure 10 on
. The console
(7)
Prime function (normal):
Signal Source feature key
Level 1 function (Shift and Conf/
Busy Lamp Field key):
Used with the Busy Lamp Field/
Console Graphics Module, as
CGM key.
(8)
Prime function (normal):
Signal Destination feature key
Level 1 function (Shift):
Used with the Busy Lamp Field/
Console Graphics Module, as the
Mode key.
Table 3
Softkey definitions and functions (Part 3 of 3)
Key number
(see Figure 10)
Symbol
Function