Paradyne COMSPHERE 3611 - Manual (Page 60)

Configuration Worksheet for TDM Mode (3 of 3)
DBM
Configuration
Options
Value
Rate(Kbps) }} 64, 56, 28.8, 24.0, 19.2, 16.8, 14.4, 12.0,
9.6, 7.2, 4.8, 2.4
TxClkSource LL }}} Int, RXC, DSU, Prt1, Prt2, Prt3, Prt4,
Prt5, Prt6
CarrLossDisc LL A Yes, No
Auto Retrain LL A Yes, No
Single Rate LLL Yes, No
Fallback } None, All, One, Two
AutoAnswer A Enab, Disab
TxElasStor Enab, Disab
RxElasStor A Enab, Disab
Call Setup None, Pswrd, Clbk, Alarm
RxPwd (10 characters)
TxPwd (10 characters)
V.13 Signl Enab, Disab
Dial Test A Enab, Disab
Primary Core A Yes, No
DtrCallCon Orig zz , Ansr, Disab
EchoCancel H A Enab, Disab
Remote DBM DD D A 2-wire, 4-wire
Wait Answer zzz A 90 ms, 300 ms, 500 ms, 1s, 2s, 3s, 4s, 5s
Bkup Timer Disab, 15s, 30s, 1m, 2m, 3m
SwitchTyp L N I -1, N I -2, AT&T, DMS100
FBR1(Kbps) } 56 L , 24, 19.2, 16.8, 14.4, 12, 9.6, 7.2, 4.8,
2.4
FBR2 (Kbps) HH 24, 19.2, 16.8, 14.4, 12, 9.6, 7.2, 4.8, 2.4
LPDA-2
Configuration
Options
Value
LPDA-2 Enab, Disab
LPDA Address 1–256
SNA Backup Enab, Disab
Code 1 (6 digits)
Code 2 (7 digits)
Backup
Configuration
Options
Value
Auto Bckup zz Enab, Disab
Backup Dir 1–10
FAOnCMI zz A Enab, Disab
AutoRestor Enab, Disab
NtwkTimOut zz min and sec (1 sec to 30 min)
RestorTimOut zz min (1 min to 60 min)
TriesTimeOut zz A min (1 min to 60 min)
MultiCall zz A Enab, Disab
General
Configuration
Options
Value
DTE Port :: EIA232, V.35
RTS Cntrl FrcOn, DTE
CTS Cntrl Std, =RTS
LSD Lead A STD, Delay, FrcOn
CTS Lead A STD, Delay, FrcOn
SystemStat A Enab, Disab
Circ Assur A Enab, Disab
Tst Pattern A AT&T, Std
RespondRDL A Enab, Disab
LL by DTE A Enab, Disab
RL by DTE A Enab, Disab
Bilat Lpbk A Enab, Disab
Ext Leads A ExtLd, Rate, RPowr
CCN by EL A Enab, Disab
SW Vers A 3.24, 4.43, 6.66, Normal
AnswExtBU A Enab, Disab
RLSD in MCMP H A Yes, No
PowerOnTst Enab, Disab
ChgMd
Configuration
Options
Value
Protocol Mode DPII, ADp
Backup Directory Dial String
1
3
4
5
6
7
8
9
10
S1 Hardware
Settings
Value
DBM Interface LLL Permissive (ON), Programmable (OFF)
Frame Ground/
Signal Ground Connected (ON), Disconnected (OFF)
EIA-232 Test Mode Enable (ON), Disable (OFF)
V.35 Test Mode Enable (ON), Disable (OFF)
} ISDN and V.34 DBMs only
}} Not available for Switched 56 DBM; Defaults to 56 kbps
}}} Ports 3–6 not available for 2-port Flex MUX models
H ISDN and Switched 56 Digital DBMs only
HH V.34 Analog DBM only
L ISDN DBM only
LL V.32 and V.34 Analog DBMs only
LLL V.32 Analog DBM only
DD D ISDN and 2-wire Switched 56 DBMs only
:: Appears when Non-Flex TDM is installed or 6-port
TDM/Flex is installed with firmware version less than 6.33
zz Not available for a DBM- X or a DSU with Primary Core set
to Yes; the DSU is disabled
zzz 4-wire Switched 56 DBM only
A Configuration options that do not appear when Full mode is
disabled using Menu from the Configuration branch.