Tdm setup configuration options, Table 4-2 – Paradyne COMSPHERE 3611 User Manual
Page 33
COMSPHERE 3600 Series Data Service Units
4-6
September 1996
3610-A2-GB48-50
Table 4-2
(1 of 3)
TDM Setup Configuration Options
*
MUX Funct: TDM
Next TDM CBrdg EBrdg None Prev
MUX Functions. Mode of operation for the TDM circuit card.
TDM – TDM mode for point-to-point multiplexing, tributary multipoint DSD, or digital-sharing configuration.
CBrdg – Bridge mode for a central-site bridge configuration (
). An installed DBM must be disabled.
EBrdg – Bridge mode for an extended bridge configuration (
). An installed DBM must be disabled.
None – Basic mode configuration; disables the MUX circuit card. None of the following configuration options appear.
Share DevA: Disab
Next Enab Disab Prev
Sharing Device A. Enable this configuration option to create one of two digital-sharing groups. This configuration option
may be used with LPDA-2 enabled. The following rules apply:
•
All ports in a group must have the same port speed.
•
All ports must be adjacent.
•
A digital-sharing group can have from 2 to 6 ports with a total of 2 ports when a 2-port TDM/Flex is installed.
Enab – Enables digital-sharing.
Disab – Disables digital-sharing.
Lowest Port#: 1
Next 1 2 3 4 5 Prev
Lowest Port Number. Allows selection of the lowest port number to be included in the digital-sharing group. This
configuration option appears if Sharing Device A is enabled and does not appear when a 2-port TDM/Flex is installed.
NOTE: Enabling Sharing Device A and accepting the defaults for configuration options Lowest Port Number and
Number of Ports in Group places Ports 1 and 2 in the digital-sharing group.
1 to 5 – Select the lowest port number.
#Ports in Gp: 2
Next 2 3 4 5 6 Prev
Number of Ports in Group. Select total number of ports to be included in the digital-sharing group. This configuration
option appears if Sharing Device A is enabled and does not appear when a 2-port TDM/Flex is installed.
NOTE: Individual ports in a digital-sharing group can be configured for streaming terminal. If streaming terminal
detection is enabled on a port and RTS for that port is ON longer than the value selected, the port’s leads are
clamped until RTS is turned Off. (See
in Table 4-4.)
2 to 6 – Selects the number of ports.
* This table presents configuration options based on MUX Function set to TDM.