Paradyne COMSPHERE 3611 - Manual (Page 27)

COMSPHERE 3600 Series Data Service Units
3-12 September 1996 3610-A2-GB48-50
Control Branch
The Control (Ctrl) branch allows you to enable or
disable the DSU’s transmitter, as well as the DBM’s, and
to display/change the status of the general purpose
external DTE leads.
496-12974-02
TOP-LEVEL MENU
Local Remot
Bckup Test Stat
Msgs
Address
Confg
Ctrl
TxCtl LEDs ExtL
DSU DBM Ports
Load Save
Displ Chang
Enab Disab
Devic
Port Select
Reset
Transmitter Control
Transmitter Control (TxCtl) allows you to:
•
Enable or disable the DSU’s transmitter (DDS
core).
•
Enable or disable individual ports in TDM or
MCMP mode.
•
Select the port that will have its circuit leads
monitored.
NOTE
If the DSU core is disabled,
enabling all ports in TDM or
MCMP mode will not enable the
DSU core. You must also enable
the DSU core separately.
LEDs
The LEDs selection is available from the Local branch.
This selection allows you to monitor any of the TDM or
MCMP ports at any given time. The LEDs on the TDM or
MCMP circuit card show which ports are being monitored
when the TDM or MCMP mode is in operation. You can
also choose to monitor the aggregate data stream.
External Leads
External Leads (ExtL) allows display of the state of
four general-purpose leads on the EIA-232/V.24 Port 1
interface. Refer to Document No. 3610-A2-GB46 for
additional information.
Reset
Selecting Reset will reset all connections and start a
power-up routine. Refer to Document No. 3610-A2-GB46
for additional information.
Remote Mode
Remote mode is not available for a multipoint
tributary. Refer to Document No. 3610-A2-GB46 for
additional information.