Paradyne Jetstream CPX-1000 - Manual (Page 88)

3. Installing the CPX-1000 1000-A2-GN22-00
3-24 February 2003
Attach OC-3
ATM Cables
After verifying the installation of hardware, proceed to connect the
required inter-system cables.
To attach OC-3 cables to the CPX:
Step 1 Remove the dust cover from the ATM fiber-optic SC connector
sockets located on the ATM panel. (Save the dust cover for re-use.)
Step 2 Plug the fiber optic cable’s transmit and receive connectors into the
ATM fiber-optic SC connector sockets.
CAUTION
CLASS 1 LASER
Laser hazard—never look directly into the OC-3 connectors.
They are a source of a laser beam, which may be invisible.
Looking directly into the fiber optic connector may seriously
harm y our eyes.
Notes
Do not mix optical modes. Using mismatched optical
fibers may result in damage to the equipment.
If you are using single mode OC-3 modules, use single
mode optical cables. If you are using multimode OC-3
modules, use multimode optical cables.
ATM 155
0160
ATM OC-3
SC Ports
Dust Cover
Tx
Rx