Paradyne Jetstream CPX-1000 - Manual (Page 3)

February 2003 B
1000-A2-GN22-00
Important Safety Instructions
1. Read and follow all warning notices and instructions marked on the product or included in the manual.
2. Slots and openings in the cabinet are provided for ventilation. To ensure reliable operation of the product and to
protect it from overheating, these slots and openings must not be blocked or covered.
3. Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous high
voltage points or other risks. Refer all servicing to qualified service personnel.
4. The power supply cord for countries other than North America is to be a minimum H05 V V-F type, min. 0.75 mm
2
,
2-conductor. Do not allow anything to rest on the power cord and do not locate the product where persons will walk
on the power cord. When powering the equipment, do not exceed the electrical ratings stated on the product
nameplate.
5. This product may only be used in a Restricted Access Location in accordance with articles 110-16, 110-16, 110-17,
and 110-18 of the National Electric Code, ANSI/NFPA 70. A Restricted Access Location is a secure area
(dedicated equipment rooms, equipment closets, or the like) for equipment where access can only be gained by
service personnel or by users who have been instructed about the reasons for the restrictions applied to the
location and about any precautions that must be taken. In addition, access into this designated secured area is
possible only through the use of a tool or lock and key, or other means of security, and is controlled by the authority
responsible for the location.
6. General purpose cables are described for use with this product. Special cables, which may be required by the
regulatory inspection authority for the installation site, are the responsibility of the customer. To reduce the risk of
fire, use only UL Listed or CSA Certified (or comparable cables which are certified for use in the country of
installation) cable(s) that are suitably rated for the application.
7. A rare phenomenon can create a voltage potential between the earth grounds of two or more buildings. If products
installed in separate buildings are interconnected, the voltage potential may cause a hazardous condition.
Consult a qualified electrical consultant to determine whether or not this phenomenon exists and, if necessary,
implement corrective action prior to interconnecting the products.
8. The equipment is intended for installation in a max. 25° C ambient temperature, in an environment that is free of
dust and dirt.
9. When installed in the final configuration, the product must comply with the applicable Safety Standards and
regulatory requirements of the country in which it is installed. If necessary, consult with the appropriate regulatory
agencies and inspection authorities to ensure compliance.
EMI Notices
UNITED STATES – EMI NOTICE:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
The authority to operate this equipment is conditioned by the requirements that no modifications will be
made to the equipment unless the changes or modifications are expressly approved by Paradyne
Corporation.
In order to maintain compliance with Part 15 limits, the supplied RJ21X cable must be used. Refer to the
installation instructions.
!
!