KORG Krome music workstasion 61key - Manual (Page 20)

Setup
16
3. Press the power switch on the KROME’s rear
panel to turn the power off.
The KROME’s internal data may be damaged if the
power is turned off while data is being written into
internal memory, such as during a Save operation.
Never turn off the power while processing is being
performed.
The following message is displayed while data is
being written into internal memory.
“Now writing into internal memory”
If writing to internal memory could not be
completed successfully, the KROME will
automatically repair the internal memory by
initializing it the next time you turn on the power.
This is not a malfunction. If this occurs, the
following message will appear in the display;
press the OK button.
The internal memory has been corrupted, likely
due to an interruption of power while the system
was writing/saving data. This has been repaired
and the affected Bank has been initialized.
A small amount of electrical power is used even
when the power is off (STANDBY). If you won’t be
using the KROME for an extended period, turn off
the power and unplug the power cord from the
AC outlet.
Auto power-off function
The KROME supports an auto power‐off function that
automatically turns off the power when the keyboard
or front panel buttons
(*)
have not been used for a
certain length of time.
* Usage of the VOLUME knob is not included.
Note: With the factory settings, the time until
automatic power‐off will be approximately four hours.
When the power turns off, the settings you had
been editing will be lost. Make sure that you save
important settings before this occurs.
Changing the auto power-off setting
If you want to change the setting so that the power
does not turn off automatically, proceed as follows to
disable the auto power‐off function.
Making the change in the dialog box immediately
after start-up
If the auto power‐off function is enabled so that the
power will turn off automatically, the dialog box will
appear immediately after start‐up, indicating the time
until automatic power‐off will occur.
1. While this message is displayed, press the Change
Setting button in the dialog box.
The following dialog box will appear.
2. Press the popup button to select the length of time
after which the power will turn off. If you don’t
want the power to turn off automatically, choose
the Disabled setting.
Changing the setting during operation
1. Press the GLOBAL button. (Alternatively, press
the mode button and choose GLOBAL.)
2. Press the EXIT button to access P0: Basic Setup.
3. Press the System Pref. tab to access the System
Preferences page.
4. In “Auto Power‐Off,” specify the amount of time
when you want the power to turn off. If you don’t
want the auto power‐off function to automatically
turn off the power, choose the Disabled setting.
Auto power-off warning message
When the specified length of time has elapsed without
any user input on the KROME, a message will appear,
warning you that the auto power‐off function is about
to turn off the power.
If you want to continue using the system, press the
keyboard, a button, or the display. The Auto power‐off
function will be reset. If the same specified length of
time elapses with no user input, the same message will
appear again.