KORG Krome music workstasion 61key - Manual (Page 127)

Media utility Formatting media
123
Media utility
Formatting media
Newly purchased media or media that has been used
by another device cannot be used “as is;” you must
format the media before you can use it with the
KROME.
When you format media, all data that had been
saved on that media will be erased. Be sure to
double‐check media for data before you format.
After formatting, it is not possible to press the
COMPARE button to return to the previous state.
1. Make sure that the media you want to format is
inserted. For details, please see “Inserting/
removing a card in the SD card slot” on page 118.
2. Access the Media– Utility page. Press the Utility
tab.
3. Press the menu button to access the menu, and
press “Format” to open the dialog box.
4. In “Volume Label,” use the text edit button to
access the text edit dialog box, and specify the
volume label.
The previously‐specified volume label will be
displayed. If no volume label had been specified for the
media, or if a non‐DOS media was inserted, this will
indicate “NEW VOLUME.”
5. Specify the initialization format.
Quick Format: This erases the file information on the
SD card, allowing the card to be formatted quickly.
Normally you’ll use this method of formatting.
Full Format: All blocks on the media will be erased.
Normally, there is no need to apply a Full Format; you
should simply execute Quick Format.
6. Press the OK button to format, or press the Cancel
button if you decide to cancel.
When you press the OK button, a message will ask you
for confirmation. Press the OK button once again to
execute the Format operation.
You must use the KROME to format the media.
The KROME will not correctly recognize media
that has been formatted by another device.
Setting the current time
Specify the date and time; this is used to record the
correct date and time when you save data. You can set
the date and time by using the Media Utility page’s Set
Date/Time menu command.
The KROME does not contain an internal calendar
or clock, you must use the Utility menu command
Set Date/Time to set the date and time before
saving the file.
1. Press the MEDIA button to enter Media mode.
2. Access the Media– Utility page. Press the Utility
tab.
3. Open the menu, and select the Set Date/Time
command.
The following dialog box will appear.
4. Use the VALUE controllers to set the correct year,
month, day, hour, minute, and second.
5. Press the OK button.