Table 2-12, Bios-ge – Sun Microsystems SUN STOREDGETM 5310 NAS User Manual
Page 74
2-28
Sun StorEdge 5310 NAS Troubleshooting Guide • December 2004
2-1-2-3
Check ROM copyright notice.
2-2-3-1
Test for unexpected interrupts.
1-5-1-1
FRB failure (processor failure)
1-5-2-2
No processors installed or processor socket 1 is empty
1-5-2-3
Processor configuration error (for example, mismatched VIDs)
1-5-2-4
Front-side bus select configuration error (for example, mismatched BSELs)
1-5-4-2
Power fault: DC power unexpectedly lost (for example, power good from the
power supply was deasserted)
1-5-4-3
Chipset control failure
1-5-4-4
Power control failure (for example, power good from the power supply did
not respond to power request)
1 The code indicates the beep sequence; for example, 1-5-1-1 means a single beep, then a
pause, then 5 beeps in a row, then a pause, then a single beep, then a pause, and then
finally a single beep.
TABLE 2-12
BIOS-Generated Boot Block POST Beep Codes
Beep
Code
Error Message
Description
1
Refresh timer failure
The memory refresh circuitry on the motherboard is faulty.
2
Parity error
Parity can not be reset
3
Base memory failure
Base memory test failure. See Table 2-13 on page 2-29 for
additional error details.
4
System timer
System timer is not operational
5
Processor failure
Processor failure detected
6
Keyboard controller Gate A20
failure
The keyboard controller may be bad. The BIOS cannot switch
to protected mode.
7
Processor exception interrupt error
The CPU generated an exception interrupt.
8
Display memory read/write error
The system video adapter is either missing or its memory is
faulty. This is not a fatal error.
9
ROM checksum error
System BIOS ROM checksum error
10
Shutdown register error
Shutdown CMOS register read/write error detected
11
Invalid BIOS
General BIOS ROM error
TABLE 2-11
BMC-Generated POST Beep Codes
Beep Code
1
Description