As-interface slaves, I/o modules for operation in the field – Siemens ISI EN 50295 User Manual

Page 47

Siemens IK PI · 2004

6/47

AS-Interface Slaves

I/O modules for operation in the field

Digital I/O modules IP67 - K60

■

Technical specifications (continued)

K60 mounting plate

Hub

For wall mounting

For rail mounting

3RK1 901-0CA00

3RK1 901-0CB00

3RK1 901-1NN00

Ambient temperature in °C

-40 to +85

Protection

IP67 with K60 compact module
screwed on

IP65 with upper part screwed on

Connection technique

For shaped AS-Interface cable,
contacted through the insulation-
piercing terminals integral to the
compact module

For yellow or black, shaped
AS-Interface cable
contacted through the insulation-
piercing terminals integral to the
upper part

Mounting

• Wall mounting

• On shaped bracket (the corre-

sponding slide rings are re-
quired)

• Hole spacing is compatible to

K45 mounting plate for wall
mounting

• Standard rail mounting

• Standard mounting rail/wall

mounting

• On shaped bracket (the corre-

sponding slide rings are re-
quired)

• Hole spacing also compatible to

coupling module FK/FK-E
(application module)

Note

Additional seals are only
necessary when the flat cables
terminate inside the module
(3RK1 902-0AR00)

Standard rail adapter can be
ordered separately as spare parts:
3RX1 660-0B

Distributors can be used for the
following purposes:

• Configuration of network struc-

tures (branch function)

• Isolation of cable segments

(isolating function)

• Sealing cable ends inside the

module (sealing function)

If one or both cables terminate in
the module, seals are required
(straight and shaped) that can
be inserted in the lower part of the
distributor. These seals are not
included in the scope of supply
and must be ordered separately
(3RK1 902-0AR00).

If both cables are routed into and
out of the module, additional seals
are not required.