Silex technology Embedded Intelligent Module SX-560 - Manual (Page 94)

Page 88 Silex Console Commands
Part Number 140-00192-100
Command Description
SH IP Shows TCP/IP related parameters
Sample Output:
IP is enabled
IP address 192.0.0.192 Boot tries 3
Subnet mask 0.0.0.0 Boot method AUTO
IP Gateway 0.0.0.0 Max window 10240
(set manually)
LPD banner disabled Timeout 1 min
LPD retries are disabled Keepalive 5 min
Service Port TCP port
xxxxxx_S1_A S1 9100
xxxxxx_S1_B S1 3001
SET IP TRAP n
TRIG mask> Specifies the trigger conditions that will cause a trap to be sent. is an
integer in hex format representing a 32-bit mask as defined below. If the
corresponding bit is 1, the trigger condition is enabled to cause the trap.
NOTE: Even if the trigger bit is set by this command, no trap will be entered if the
underlying trigger has not been configured.
Bit# Hex Value Trigger Condition
0 00000001 Serial Server: Match string 1
1 00000002 Serial Server: Match string 2
2 00000004 Serial Server: Match string 3
3 00000008 Serial Server: Match string 4
4 00000010 Serial Server: Match string 5
5 00000020 Serial Server: Match string 6
6 00000040 Serial Server: Match string 7
7 00000080 Serial Server: Match string 8
8 00000100 undefined
9 00000200 undefined
10 00000400 undefined
11 00000800 undefined
12 00001000 undefined
13 00002000 undefined
14 00004000 undefined
15 00008000 undefined
16 00010000 GPIO Trigger1: GPIO1 0 to 1
17 00020000 GPIO Trigger2: GPIO2 0 to 1
18 00040000 GPIO Trigger3: GPIO3 0 to 1