Silex technology Embedded Intelligent Module SX-560 - Manual (Page 67)

Advanced Configuration Silex Page 61
Part Number 140-00192-100
Configuring Serial Port Monitor Alert and Trap Configuration
The SX-560 module can be configured to scan and compare the data received on the serial port to user-
defined strings. A match with a string can be a source for SNMP traps and/or email alerts.
The match strings and corresponding email or web page message strings are configured from the Internal
Configuration Console interface.
Table 27 describes the Monitor Alert and Trap Configuration Commands (the examples are for serial port
1; for serial port 2, substitute the port name S2 instead of S1.
Table 27 Port Monitor Alert Commands
Command Description
SHOW PORT S1 TRIGMON Shows strings and index numbers being monitored
SET PORT S1 TRIGMON <trig #> Assigns a string to be monitored on the serial port
Example:
Local> show port s1 trigmon
Index # Monitor String
------ --------------
Local> set port s1 trigmon 0 trigger on seeing this string
Local> show port s1 trigmon
Index # Monitor String
------ --------------
0: trigger on seeing this string
SHOW PORT S1 TRIGXMT Shows email or web page strings associated with
TRIGMON index numbers
SET PORT S1 TRIGXMT #>
Index # = 0 to 7
Assigns email or web page string to specified
TRIGMON index number
Example:
Local> show port s1 trigxmt
Index # Xmit String
------ ---------------
0: xmit string 0 <<< default msg string
Local> set port s1 trigxmt 0 The trigger string was seen!
Local> show port s1 trigxmt
Index # Xmit String
------ ---------------
0: The trigger string was seen!