Mocomtech CIM-550 - Manual (Page 93)

CiM-550 IP Enabled Satellite Modem Rev. 2
Remote Control CD/CIM550.IOM
67
Parameter
Type Command
(Instruction
Code and
qualifier)
Arguments for
Command or
Response to
Query
Description of arguments
(note that all arguments are ASCII numeric
codes, that is, ASCII codes between 48 and 57)
Response to Command
(target to controller)
Query
(Instruction
Code and
qualifier)
Response to
query
(target to
controller)
1 = +/- 256 bits
2 = +/- 512 bits
3 = +/- 1024 bits
4 = +/- 2048 bits
5 = +/- 4096 bits but invalid argument found)
RBS* (message ok, but not
permitted in current mode)
command
argument)
Unit
Interface
Type ITF= 1 byte, value of
1,2,3 or 4
Command or Query.
Terrestrial interface type, where:
1 = EIA-422/EIA530 DCE,
2 = V.35 DCE
3 = EIA-232 (sync).
4 = IP interface
All other codes invalid. Example: ITF=2 (V.35) ITF= (message ok)
ITF? (received ok, but
invalid args found)
ITF* (message ok, but not
permitted in current mode)
ITF? ITF=x
(same format
as command
argument)
IP Address
and network
prefix
IPA= 18 bytes,
numerical
Command or Query.
IP Address and network prefix in the following
format:
xxx.xxx.xxx.xxx.yy
Where:
xxx.xxx.xxx.xxx is the address and yy is the
network prefix (0-31)
Example: IPA=010.006.030.001/24
IPA= (message ok)
IPA? (received ok,
but invalid arguments found)
IPA* (message ok, but not
permitted in current mode)
IPA? IPA=xxx.xxx.xxx
.xxx.yy
(same format as
command
arguments)
Unit
Framing
Mode
FRM= 1 byte, value of
0 or 1
Command or Query.
Unit operating mode, where
0 = Unframed - transparent (distant-end M&C not
possible)
1 = Framed (EDMAC distant-end M&C possible)
Example: FRM=1 (which is framed) FRM= (message ok)
FRM? (received ok,
but invalid argument found)
FRM* (message ok, but not
permitted in current mode)
FRM? FRM=x
(same format as
command
argument)
Unit Test TST= 1 byte, value of
0 1 2 3 4
0 = Normal TST= (message ok) TST? TST=x