Mocomtech CIM-550 - Manual (Page 49)

CiM-550 IP Enabled Satellite Modem Rev. 2
Front Panel Menus CD/CIM550.IOM
23
4.1.3 L ED I NDICATORS
There are 8 LED indicators. The functions of these indicators are shown in the table
below.
Table 4-1. Front Panel LED Indicators
LED Color Condition
Red A Unit Fault exists (Example: PSU fault)
Orange No Unit Faults, but a Traffic Fault exists
Unit Status
Green No Unit Faults, or Traffic Faults
Green No Tx Traffic Faults Transmit Traffic
Off A Tx Traffic fault exists OR the Tx Carrier is in OFF state
Green
No Rx Traffic Faults (demod and Viterbi decoder are
locked, everything is OK) Receive Traffic
Off An Rx Traffic fault exists (the demod may still be OK)
Green The Unit is On Line, and carrying traffic On line
Off
The Unit is Off Line (standby) - forced by externally
connected 1:1 or 1:N redundancy system
Orange
There is a Stored Event in the log, which can be viewed
from the front panel, or retrieved via the remote control
interface Stored Event
Off There are no Stored Events
Orange
The Unit is in Remote Mode - local monitoring is possible,
but no local control Remote
Off
The Unit is in Local Mode - remote monitoring is possible,
but no remote control
Orange Framing on, EDMAC on, and unit defined as Slave EDMAC Mode
Off
Either no EDMAC, EDMAC Master, or Transparent mode
is selected
Orange A Test Mode is selected (Example: IF Loopback) Test Mode
Off There is no Test Mode currently selected
4.1.4 M ENU T REE
The following figures show the menu structure of the CiM-550 front panel menu. The
detailed screens and menus are described in subsequent paragraphs.