Mocomtech CIM-550 - Manual (Page 104)

CiM-550 IP Enabled Satellite Modem Rev. 2
Remote Control CD/CIM550.IOM
78
Parameter
Type Command
(Instruction
Code and
qualifier)
Arguments for
Command or
Response to
Query
Description of arguments
(note that all arguments are ASCII numeric
codes, that is, ASCII codes between 48 and 57)
Response to Command
(target to controller)
Query
(Instruction
Code and
qualifier)
Response to
query
(target to
controller)
0 = Off Line (forced into standby by 1:N or 1:1
Switch) 1= On Line (normal). All other codes
invalid. Example: RED=1 (On Line)
arguments)
Local/Remot
e Status
LRS= 1 byte, value of
0 or 1
Command or query (Command only if S/W > 1.13)
As a query, returns the local/remote status of the
unit, where:
0 = local
1= remote
When used as a comand, uses the same codes for
an argument.
Example: LRS=1 (unit is in remote mode)
LRS=
(message ok) LRS? LRS=x (see
description for
details of
arguments)
Serial
Number
SNO= 4 bytes
numerical
0000 to 9999
Command portion is FACTORY USE ONLY. Used
to set or Query the units 4 digit serial number.
Unit returns its S/N, in the form xxxx.
Example: SNO=1765
SNO= (message ok) SNO? SNO=xxxx (see
description for
details of
arguments)
Software
Revision
N/A 4 bytes,
numerical Query only.
Unit returns the value of internal software revision
installed in the unit, in the form x.xx
Example: SWR=1.03 (Ver 1.03)
N/A SWR? SWR=x.xx (see
description for
details of
arguments)
Equipment
ID N/A 6 bytes,
numerical
Query only.
Unit returns the equipment identification, and the
options fitted, in the form aaaabc, where:
aaaa defines the Modem model number. Example:
2550 is CiM-550, no Reed-Solomon or Turbo 3550
is CiM-550 with Reed-Solomon Codec
4550 is CiM-550 with Turbo Codec fitted (Rate 3/4
QPSK only - S/W Version less than 1.15)
5550 is CiM-550 with Turbo Codec fitted (Rate 3/4
QPSK, plus Rate 21/44 and Rate 5/16 BPSK)
N/A EID? EID=aaaabc
(see description
for details of
arguments)