Mocomtech CIM-550 - Manual (Page 91)

CiM-550 IP Enabled Satellite Modem Rev. 2
Remote Control CD/CIM550.IOM
65
Parameter
Type Command
(Instruction
Code and
qualifier)
Arguments for
Command or
Response to
Query
Description of arguments
(note that all arguments are ASCII numeric
codes, that is, ASCII codes between 48 and 57)
Response to Command
(target to controller)
Query
(Instruction
Code and
qualifier)
Response to
query
(target to
controller)
Note: If the RS Codec option is not installed, and
the argument 3 or 4 is used, the target will return
RFT? If the Turbo Codec option is not installed,
and the argument 5, 6 or 7 is used, the target will
return RFT? Use EID? to query the options fitted.
Rx FEC
Code Rate RCR= 1 byte, value of
1,3 or 7
Command or Query.
Rx FEC Code rate, where:
1 = Rate 1/2
3 = Rate 3/4 (must be set for Rate 3/4 Turbo)
7 = Rate 7/8
8 = Rate 21/44 (must set for Rate 21/44 Turbo)*
9 = Rate 5/16 (must set for Rate 5/16 Turbo)*
All other codes invalid.
Example: RCR=1 (which is Rate 1/2)
* Only valid for S/W Version >1.14
As a Query, returns 0 if Uncoded is selected for
FEC
RCR= (message ok)
RCR? (received ok,
but invalid argument found)
RCR* (message ok, but not
permitted in current mode
RCR? RCR=x
(same format as
command
argument)
Rx
Modulation
Type
RMD=
1 byte, value of
1or 2 or 3
Command or Query.
Rx Modulation type, where:
1 = BPSK (must be set for Rate 21/44 or 5/16
Turbo)
2 = QPSK (must be set for Rate 3/4 Turbo
operation)
3 = OQPSK
All other codes invalid.
Example: RMD=1 (BPSK)
RMD= (message ok)
RMD? (received ok,
but invalid argument found)
RMD* (message ok, but not
permitted in current mode) RMD?
RMD=x
(same format as
command
argument)
Rx
Spectrum
Invert
RSI= 1 byte, value of
0 or 1 Command or Query.
Rx Spectrum Invert selection, where: RSI= (message ok)
RSI? (received ok, RSI?
RSI=x
(same format as
command