Gateway 840 VT-100 - Manual (Page 227)

222
Chapter 10: Diagnostics
www.gateway.com
3
From the Online Diagnostics menu, select Target Command Trace Settings ,
then press E NTER . The Target Command Trace Settings screen opens.
4
From the Target Command Trace Settings screen, press E NTER to toggle the
command trace to be Enabled or Disabled.
When enabled, all incoming commands will be displayed on the terminal
until the trace mode is disabled.
5
Press E SC to return to the previous menu.
Important The command is on port 1 (T1) from the host with ID 124
(ID:7c) for LUN 0. The command is a SCSI inquiry
command (CDB: 12).