Gateway 840 VT-100 - Manual (Page 13)

8
Chapter 2: Accessing the Configuration Utility
www.gateway.com
3
From the computer or terminal connected to the RAID controller, start your
terminal emulation software.
4
From the terminal window, press C TRL + W. The Main Menu opens.
You can now perform all of the functions described in the following chapters.
All steps begin from the Main Menu.
If an event or error occurs, you can review the log for the problem by examining
the event log (see
“Event Logs” on page 173 ).
Important Make sure that your terminal emulation software is set to
use the correct COM port on your computer.