Accessing the utility – Gateway 840 VT-100 User Manual
Page 11
6
Chapter 2: Accessing the Configuration Utility
www.gateway.com
Accessing the utility
You can access the SATA RAID controller by using a VT-100 terminal connected
to the RS-232 serial ports on the controller’s rear panel. Configure your terminal
using the procedures described in
“Using the VT-100 terminal” on page 7
.
Important
You can also choose to use StorView Storage
Management software to manage and monitor the
enclosure and SATA RAID Controller. Refer to the
Gateway
840 SATA RAID StorView User’s Guide for more
information.