FUJITSU PRIMERGY BX600 S2 - Manual (Page 43)

PRIMERGY BX600 S2 Basic Unit 43
Installing the Hardware Connecting External Devices
Figure 10: Special cable
4.4.1 Cable Routing
The cables are routed directly on the rack support uprights.
PCI Cards with Cable at the Front
If a PCI expansion module is installed in a server blade, you will have to connect
the PCI port with an external device on the back of the rack. To route the cable
from the front to the back of the rack, use the side slots of the rack with a cable
bezel as shown in
figure 11 below. You may also route the cable to the back of
the rack, using the space below the basic unit.
VGA mouse
(green) keyboard
(purple) to rear
KVM board