FUJITSU PRIMERGY BX600 S2 - Manual (Page 115)

PRIMERGY BX600 S2 Basic Unit 115
FC Pass-Thru Blade Fibre Channel SFP module
11.2 Fibre Channel SFP module
A Fibre Channel SFP module is required to connect an FC pass-thru blade port
to a Fibre Channel cable. If no cable is plugged in, the SFP module slots must
be fitted with a safety plug as shown in the figure below.
Figure 66: Fibre Channel SFP connector
Inserting a Fibre Channel SFP module
For each server blade connected via Fibre Channel, SFP modules must be
plugged into the appropriate FC pass-thru blade slots. For information on the
port assignment see
section “Installation Sequence” on page 73 .