FUJITSU ServerView V6.00 - Manual (Page 69)

ServerView Event Manager 69
Making pager settings (COM port and modem)
4.7 Making pager settings
(COM port and modem)
If you have selected Pager for the forwarding, the New Pager Configuration window
opens. In this window you can use the Pager Settings and Modem Settings tabs to
make the different settings for the serial interfaces and the modems connected
to them (pager types).
You can define the following values:
– The name of the available interfaces (e.g. COM2 or COM4)
– The maximum transmission speed (baud rate)
– The type of data flow control
– The initialization and reset chain for the modem
The input fields in the New Pager Configuration window have the following
meanings:
Name Meaning
Description Name of the pager settings
Owner Name of the owner
Com Port Name of the serial interfaces.
The drop-down list contains the names of the available
interfaces. You can select a specific interface or the entry
Any
Available . If you select the latter, any available interface can be
connected to your COM ports. This is useful if you frequently
change the attached devices.
Pager Number (Telephone) number of the pager
I
With a text message the destination number may have
to be preceded by an additional prefix of the relevant
pager service.
For example:
D1 service in Germany: 49171XXXXXXX
(XXXXXXX = pager ID)
Must be prefixed by 49171 (without 00)
D2 service in Germany: 0049172XXXXXXX
0049172 is optional
Table 12: Input fields in the Mail Settings window