HP XW3400 - Manual (Page 44)

9 . If the system did not automatically restart when exiting FDISK, press Ctrl + Alt + Del to reboot to the
DOS diskette.
10 . At the A:\ prompt, type FORMAT C: /S and press Enter . Format will format the USB flash media
device, add the system files, and ask for a Volume Label.
11 . Press Enter for no label or enter one if desired.
12 . Turn off the workstation and unplug the power cord. Open the workstation and re-install any PCI
cards that were previously removed. Close the workstation cover.
13 . Plug in the power cord, remove the diskette, and turn on the workstation.
14 . As soon as the workstation is turned on, press F10 when the monitor light turns green to enter
Computer Setup. Press Enter to bypass the title screen, if necessary.
15 . Go to Advanced > PCI Devices and re-enable the PATA and SATA controllers that were disabled
in step 6. Put the SATA controller on its original IRQ.
16 . Save the changes and exit. The workstation will boot to the USB flash media device as drive C.
NOTE: The default boot order varies from workstation to workstation, and it can be changed in
the Computer Setup (F10) Utility. Refer to Section 2.2 for instructions.
If you have used a DOS version from Windows 9x, you may see a brief Windows logo screen. If
you do not want this screen, add a zero-length file named LOGO.SYS to the root directory of the
USB flash media device.
Return to Copying to multiple workstations on page 30 .
Dual-State power button
With Advanced Configuration and Power Interface (ACPI) enabled, the power button can function either
as an on/off switch or as a standby button. The standby feature does not completely turn off power, but
instead causes the workstation to enter a low-power standby state. This allows you to power down quickly
without closing applications and to return quickly to the same operational state without any data loss.
To change the power button’s configuration, complete the following steps:
1 . Left click on the Start Button, then select Control Panel > Power Options.
2 . In the Power Options Properties, select the Advanced tab.
3 . In the Power Button section, select Stand by.
After configuring the power button to function as a standby button, press the power button to put the system
in a very low power state (standby). Press the button again to quickly bring the system out of standby to
full power status. To completely turn off all power to the system, press and hold the power button for four
seconds.
CAUTION: Do not use the power button to turn off the workstation unless the system is not responding;
turning off the power without operating system interaction could cause damage to or loss of data on the
hard drive.
34 Chapter 4 Desktop management ENWW