HP XW3400 - Manual (Page 119)

Control panel message Description Recommended action
RTC (real-time clock) battery may need to
be replaced.
See the Hardware Reference Guide on the
Documentation and Diagnostics CD for
instructions on installing a new battery, or
contact an authorized dealer or reseller for
RTC battery replacement.
163-Time & Date Not Set CMOS jumper may not be properly installed. Check for proper placement of the CMOS
jumper if applicable.
164-MemorySize Error Memory amount has changed since the last
boot (memory added or removed).
Press the F1 key to save the memory changes.
164-MemorySize Error Memory configuration incorrect. 1 . Run Computer Setup or Windows
utilities.
2 . Make sure the memory module(s) are
installed properly.
3 . If third-party memory has been added,
test using HP-only memory.
4 . Verify proper memory module type.
201-Memory Error RAM failure. 1 . Run Computer Setup or Windows
utilities.
2 . Ensure memory modules are correctly
installed.
3 . Verify proper memory module type.
4 . Remove and replace the identified faulty
memory module(s).
5 . If the error persists after replacing
memory modules, replace the system
board.
213-Incompatible Memory Module in
Memory Socket(s) X, X, ...
A memory module in memory socket identified
in the error message is missing critical SPD
information, or is incompatible with the
chipset.
1 . Verify proper memory module type.
2 . Try another memory socket.
3 . Replace DIMM with a module
conforming to the SPD standard.
214-DIMM Configuration Warning Populated DIMM Configuration is not
optimized.
Rearrange the DIMMs so that each channel
has the same amount of memory.
219-ECC Memory Module Detected ECC
Modules not supported on this Platform
Recently added memory module(s) support
ECC memory error correction.
1 . If additional memory was recently
added, remove it to see if the problem
remains.
2 . Check product documentation for
memory support information.
301-Keyboard Error Keyboard failure. 1 . Reconnect keyboard with workstation
turned off.
2 . Check connector for bent or missing pins.
3 . Ensure that none of the keys are
depressed.
4 . Replace keyboard.
Table C-1 Numeric Codes and Text Messages (continued)
ENWW POST numeric codes and text messages 109