HP XW3400 - Manual (Page 156)

Network status link light never flashes.
NOTE: The network status light is supposed to flash when there is network activity.
Cause Solution
Network driver is not properly loaded. Reinstall network drivers. See the Network & Internet
Communications Guide on the Documentation and Diagnostics
CD.
System cannot autosense the network. Disable auto-sensing capabilities and force the system into the
correct operating mode. See the Network & Internet
Communications Guide on the Documentation and Diagnostics
CD.
Diagnostics reports a failure.
Cause Solution
The cable is not securely connected. Ensure that the cable is securely attached to the network
connector and that the other end of the cable is securely
attached to the correct device.
The cable is attached to the incorrect connector. Ensure that the cable is attached to the correct connector.
There is a problem with the cable or a device at the other end
of the cable.
Ensure that the cable and device at the other end are operating
correctly.
Network controller interrupt is shared with an expansion board. Under the Computer Setup Advanced menu, change the
resource settings for the board.
The network controller is defective. Replace the network controller.
Diagnostics passes, but the workstation does not communicate with the network.
Cause Solution
Network drivers are not loaded, or driver parameters do not
match current configuration.
Make sure the network drivers are loaded and that the driver
parameters match the configuration of the network controller.
Make sure the correct network client and protocol is installed.
The network controller is not configured for this workstation. Select the Network icon in the Control Panel and configure
the network controller.
Network controller stopped working when an expansion board was added to the workstation.
Cause Solution
Network controller interrupt is shared with an expansion board. Under the Computer Setup Advanced menu, change the
resource settings for the board.
The network controller requires drivers. Verify that the drivers were not accidentally deleted when the
drivers for a new expansion board were installed.
The expansion board installed is a network card (NIC) and
conflicts with the embedded NIC.
Under the Computer Setup Advanced menu, change the
resource settings for the board.
Table D-12 Solving Network Problems (continued)
146 Appendix D Troubleshooting without diagnostics ENWW