HP XW3400 - Manual (Page 118)

POST numeric codes and text messages
This section covers those POST errors that have numeric codes associated with them. The section also
includes some text messages that may be encountered during POST.
NOTE: The workstation will beep once after a POST text message is displayed on the screen.
Table C-1 Numeric Codes and Text Messages
Control panel message Description Recommended action
101-Option ROM Checksum Error System ROM or expansion board option ROM
checksum.
1 . Verify the correct ROM.
2 . Flash the ROM if needed.
3 . If an expansion board was recently
added, remove it to see if the problem
remains.
4 . Clear CMOS.
5 . If the message disappears, there may
be a problem with the expansion card.
6 . Replace the system board.
103-System Board Failure DMA or timers. 1 . Clear CMOS.
2 . Remove expansion boards.
3 . Replace the system board.
110-Out of Memory Space for Option ROMs Recently added PCI expansion card contains
an option ROM too large to download during
POST.
1 . If a PCI expansion card was recently
added, remove it to see if the problem
remains.
2 . In Computer Setup, set Advanced >
Device Options > NIC PXE Option
ROM Download to DISABLE to
prevent PXE option ROM for the internal
NIC from being downloaded during
POST to free more memory for an
expansion card's option ROM. Internal
PXE option ROM is used for booting from
the NIC to a PXE server.
3 . Ensure the ACPI/USB Buffers @ Top of
Memory setting in Computer Setup is
enabled.
162-System Options Not Set Configuration incorrect.
RTC (real-time clock) battery may need to
be replaced.
Run Computer Setup and check the
configuration in Advanced > Onboard
Devices.
Reset the date and time under Control
Panel. If the problem persists, replace the
RTC battery. See the Hardware Reference
Guide on the Documentation and Diagnostics
CD for instructions on installing a new battery,
or contact an authorized dealer or reseller for
RTC battery replacement.
163-Time & Date Not Set Invalid time or date in configuration memory. Reset the date and time under Control
Panel (Computer Setup can also be used). If
the problem persists, replace the RTC battery.
108 Appendix C POST error messages ENWW