HP XW3400 - Manual (Page 168)

Solving software problems
Most software problems occur as a result of the following:
● The application was not installed or configured correctly.
● There is insufficient memory available to run the application.
● There is a conflict between applications.
● Be sure that all the needed device drivers have been installed.
● If you have installed an operating system other than the factory-installed operating system, check to
be sure it is supported on the system.
NOTE: HP Backup and Recovery Manager can be used to restore the software to a recovery point or
to restore the system to its factory configuration. Refer to Creating a disc recovery set on page 2 for more
information.
If you encounter software problems, see the applicable solutions listed in the following table.
Table D-19 Solving Software Problems
Workstation will not continue and no HP logo screen has appeared.
Cause Solution
POST error has occurred. Observe the beeps and LED lights on the front of the workstation.
See Appendix A, POST error messages on page 107 to
determine possible causes.
See the Restore Kit or the Worldwide Limited Warranty for terms
and conditions.
Workstation will not continue after HP logo screen has appeared.
Cause Solution
System files may be damaged. Restore the files from the Recovery Disc Set or backups you
created in HP Backup and Recovery Manager.
“Illegal Operation has Occurred” error message is displayed.
Cause Solution
Software being used is not Microsoft-certified for your version
of Windows.
Verify that the software is certified by Microsoft for your version
of Windows (see program packaging for this information).
Configuration files are corrupt. If possible, save all data, close all programs, and restart the
workstation.
158 Appendix D Troubleshooting without diagnostics ENWW