HP XW3400 - Manual (Page 138)

Cannot format diskette.
Cause Solution
Invalid media reported. When formatting a disk in MS-DOS, you may need to specify
diskette capacity. For example, to format a 1.44-MB diskette,
type the following command at the MS-DOS prompt:
FORMAT A: /F:1440
Disk may be write-protected. Open the locking device on the diskette.
Legacy diskette writes are disabled in Computer Setup. Enter Computer Setup and enable Legacy Diskette Write
in Storage > Storage Options.
A problem has occurred with a disk transaction.
Cause Solution
The directory structure is bad, or there is a problem with a file. In Windows XP, right-click Start, click Explore, and select a
drive. Select File > Properties > Tools. Under Error-
checking, click Check Now.
Diskette drive cannot read a diskette.
Cause Solution
You are using the wrong diskette type for the drive type. Check the type of drive that you are using and use the correct
diskette type.
You are reading the wrong drive. Check the drive letter in the path statement.
Diskette is damaged. Replace the diskette with a new one.
“Invalid system disk” message is displayed.
Cause Solution
A diskette that does not contain the system files needed to start
the workstation has been inserted in the drive.
When drive activity stops, remove the diskette and press the
Spacebar . The workstation should start up.
Diskette error has occurred. Restart the workstation by pressing the power button.
Cannot Boot to Diskette.
Cause Solution
Diskette is not bootable. Replace with a bootable diskette.
Diskette boot has been disabled in Computer Setup. 1 . Run Computer Setup and enable diskette boot in
Storage > Boot Order.
2 . Run Computer Setup and enable diskette boot in
Storage > Storage Options > Removable Media
Boot.
Table D-3 Solving Diskette Problems (continued)
128 Appendix D Troubleshooting without diagnostics ENWW