110 appendix c post error messages enww – HP XW3400 User Manual
Page 120

Control panel message
Description
Recommended action
303-Keyboard Controller Error
I/O board keyboard controller.
1
.
Reconnect keyboard with workstation
turned off.
2
.
Replace the system board.
304-Keyboard or System Unit Error
Keyboard failure.
1
.
Reconnect the keyboard with workstation
turned off.
2
.
Ensure that none of the keys are
depressed.
3
.
Replace the keyboard.
4
.
Replace the system board.
404-Parallel Port Address Conflict Detected
Both external and internal ports are assigned
to parallel port X.
1
.
Remove any parallel port expansion
cards.
2
.
Clear CMOS.
3
.
Reconfigure card resources and/or run
Computer Setup.
410-Audio Interrupt Conflict
IRQ address conflicts with another device.
Enter Computer Setup and reset the IRQ in
Advanced > Onboard Devices.
411-Network Interface Card Interrupt Conflict IRQ address conflicts with another device.
Enter Computer Setup and reset the IRQ in
Advanced > Onboard Devices.
501-Display Adapter Failure
Graphics display controller.
1
.
Reseat the graphics card (if applicable).
2
.
Clear CMOS.
3
.
Verify monitor is attached and turned on.
4
.
Replace the graphics card (if possible).
510-Flash Screen Image Corrupted
Flash Screen image has errors.
Reflash the system ROM with the latest BIOS
image.
511-CPU, CPUA, or CPUB Fan not Detected
CPU fan is not connected or may have
malfunctioned.
1
.
Reseat CPU fan.
2
.
Reseat fan cable.
3
.
Replace CPU fan.
512-Chassis, Rear Chassis, or Front Chassis
Fan not Detected
Chassis, rear chassis, or front chassis fan is not
connected or may have malfunctioned.
1
.
Reseat chassis, rear chassis, or front
chassis fan.
2
.
Reseat fan cable.
3
.
Replace chassis, rear chassis, or front
chassis fan.
514-CPU or Chassis Fan not Detected
CPU or chassis fan is not connected or may
have malfunctioned.
1
.
Reseat CPU or chassis fan.
2
.
Reseat fan cable.
3
.
Replace CPU or chassis fan.
601-Diskette Controller Error
Diskette controller circuitry or floppy drive
circuitry incorrect.
1
.
Run Computer Setup.
2
.
Check and/or replace cables.
3
.
Clear CMOS.
Table C-1
Numeric Codes and Text Messages (continued)
110 Appendix C POST error messages
ENWW