General settings – Interlogix TruVision NVR 10 User Manual User Manual
Page 85

Chapter 10: Live view
TruVision NVR 10 User Manual
79
General settings
Use this window to configure the monitor image, GUI language, login password
requirement, monitor resolution as well as to configure the NVR name and address.
See Figure 20 below.
The NVR can support NTSC or PAL video output. The video format is auto detected.
The changes are immediately implemented once Apply is clicked to save the settings.
Figure 20: Monitor setup window: General Settings
Table 11: Description of the Monitor setup window: General Settings
Option
Description
1.
Language
Change the language of the system.
Select the desired language from the drop-down list and click
Apply
. The
language displayed changes immediately.
2.
Device Name
Define the NVR name. The default name is TVN 10.
Click the edit box and enter the new name from the soft keyboard.
3.
Device Address
The device number to use for the NVR when programming the remote
control. The default value is 255.
4.
Resolution
Define the monitor resolution.
Select one of the options from the drop-down list and click
Apply
. The
selected resolution must be the same as that of the monitor.
5.
Password Required
Define whether a login password is required.
Check the box to enable/disable and click
Apply
.
6.
Enable Wizard
Define whether the wizard tool starts when the NVR is turned on.
Check the box to enable/disable and click
Apply
.
7.
Display Status Icons
Define whether the status icons are displayed.