Interlogix TruVision NVR 10 User Manual - Manual (Page 40)

Chapter 5: Recording settings
34 TruVision NVR 10 User Manual
Note: You must set the storage mode of the HDD to Group before configuring
redundancy. See “Setting up HDD groups” on page 58 for more information.
To set up HDD redundancy:
1. Set which cameras will be recorded on which HDD.
From the menu toolbar, click System Settings > Hard Disk > Storage Mode .
Under Mode , select Group .
Under Record on HDD Group , select the HDD group number. Check the channels
to be added to this group.
Note: By default, all channels belong to HDD group 1.
Click Apply to save the settings.
2. Set which HDD will be read/write (R/W) and which HDD will mirror the R/W HDD.
Click the HDD Information tab and select the HDD to be used for redundancy and
click Edit . In the Local HDD Settings screen, select Redundancy . Verify at least
one other HDD is set to R/W.
Click Apply to save the settings and then OK return to the previous screen.
3. Click Back to return to live view.