8e6 Technologies Enterprise Filter Authentication R3000 - Manual (Page 43)

C
HAPTER
1: I
NTRODUCTION
A
UTHENTICATION
S
OLUTIONS
8
E
6 T
ECHNOLOGIES
, R3000 I
NTERNET
F
ILTER
A
UTHENTICATION
U
SER
G
UIDE
29
Configuring the R3000 for Authentication
Configuration procedures
When configuring the R3000 server for authentication,
settings must be made in System and Group windows in the
Administrator console.
NOTES: If the network has more than one domain, the first one
you add should be the domain on which the R3000 resides.
The entries described in this section represent entries to be made
on a typical network
.
System section
The first settings for authentication must be made in the
System section of the Administrator console in the following
windows: Operation Mode, LAN Settings, Enable/Disable
Authentication, Authentication Settings, Authentication SSL
Certificate (if Web-based authentication will be used), and
Block Page Authentication.
1. Select “Mode” from the navigation panel, and then select
“Operation Mode” from the pop-up menu.
The entries made in the Operation Mode window will vary
depending on whether you will be using the invisible
mode, or the router or firewall mode.
In the Listening Device frame, set the Listening Device to
“LAN1”.
In the Block Page Device frame:
• If using the invisible mode, select “LAN2”.
• If using the router or firewall mode, select “LAN1”.
2. Select “Network” from the navigation panel, and then
select “LAN Settings” from the pop-up menu.