beautypg.com

Conformity to ec directives and ul standards, Composition of peripheral equipments, Ec directives – Panasonic MINAS A4P Series User Manual

Page 176: Emc directives, Conformed standards, Installation environment

background image

176

Conformity to EC Directives and UL Standards

Control box

Controller

Insulated power supply

for interface

Power

supply

Circuit

breaker

Protective earth (PE)

L1

U

CN X5

CN X1

CN X2

CN X6

M

RE

V

W

L2

L3

L1C

L2C

Driver

Ground-fault

breaker (RCD)

Surge

absorber

Noise filter

Noise filters for

signal lines

Noise filters
for
signal lines

Motor

Motor

Motor/
Motor

and

driver

Conforms to Low-
Voltage Directives

Standards
referenced by
EMC Directives

Subject

Conformed Standard

IEC60034-1 IEC60034-5 UL1004 CSA22.2 No.100
EN50178 UL508C

EN55011

Radio Disturbance Characteristics of Industrial, Scientific

and Medical (ISM) Radio-Frequency Equipment
EN61000-6-2

Immunity for Industrial Environments

IEC61000-4-2

Electrostatic Discharge Immunity Test

IEC61000-4-3

Radio Frequency Electromagnetic Field Immunity Test

IEC61000-4-4

Electric High-Speed Transition Phenomenon/Burst Immunity Test

IEC61000-4-5

Lightening Surge Immunity Test

IEC61000-4-6

High Frequency Conduction Immunity Test

IEC61000-4-11

Instantaneous Outage Immunity Test

EC Directives

The EC Directives apply to all such electronic products as those having specific functions and have been
exported to EU and directly sold to general consumers. Those products are required to conform to the EU
unified standards and to furnish the CE marking on the products.
However, our AC servos meet the relevant EC Directives for Low Voltage Equipment so that the machine or
equipment comprising our AC servos can meet EC Directives.

EMC Directives

MINAS Servo System conforms to relevant standard under EMC Directives setting up certain model (condi-
tion) with certain locating distance and wiring of the servo motor and the driver. And actual working condition
often differs from this model condition especially in wiring and grounding. Therefore, in order for the machine
to conform to the EMC Directives, especially for noise emission and noise terminal voltage, it is necessary to
examine the machine incorporating our servos.

Conformed Standards

IEC : International Electrotechnical Commission
EN

: Europaischen Normen

EMC : Electromagnetic Compatibility
UL

: Underwriters Laboratories

CSA : Canadian Standards Association


Use options correctly after reading operation manuals of the options to better understand the precautions.
Take care not to apply excessive stress to each optional part.

Composition of Peripheral Equipments

Installation Environment

Use the servo driver in the envi-
ronment of Pollution Degree 1 or
2 prescribed in IEC-60664-1 (e.g.
Install the driver in control panel
with IP54 protection structure.)